Insulated BattenLok and CFR Fasteners

Components>Accessories>Insulated Metal Panel Accessories>Insulated BattenLok and CFR Fasteners

1/4″-14 x 2″ TEK3 w/o washer
(2) fasteners per roof clip.
Factory Mutual Requirements: (3) fasteners per roof clip when attached to support members less than 12 gauge
Use in 16 gauge – 12 gauge steel
This Fastener can be purchased in any quantity – Increments of 250 are not required

Clip Fastener

Head Size Type Carton Size
5/16″ Driller 750

1/4″-14 x 2″ Type B w/o Washer
This Fastener can be purchased in any quantity – Increments of 250 are not required.
Use: Optional fastener to #1616 and #1724 series.
Pilot Hole: The proper sizing of the pilot holes drilled in different gauge steel is critical for self tapping screws
Limitations: 1/16″to 1/2″ thick

Clip Fastener

Head Size Type Carton Size
3/8″ B 1000

1/4″-14 x 2″ Type B 304 Stainless w/o Washer
This Fastener can be purchased in any quantity – Increments of 250 are not required.
Stainless: Stainless is provided based on customer requirements, primarily when the panels will be installed in a corrosive environment (coastal location, exposure to chemicals, etc.).
Pilot Hole: The proper sizing of the pilot holes drilled in different gauge steel is critical for self tapping screws
Limitations: 1/16″to 1/2″ thick

Clip Fastener

Head Size Type Carton Size
3/8″ B 1000

1/4″-14 x A” HWH w/ Washer
This Fastener can be purchased in any quantity – Increments of 250 are not required
Thru-Panel fasteners with washers are used to attach the panels to the supports from the exterior face. The washer provides a seal where the fastener penetrates the panel, and they are typically placed at the low point of the mesa pattern.
CFR Rake Through Panel Fastener

Through Panel Fastener

Length “A” Head Size Panel Thickness Carton Size
3″ 3/8″ 2″ 500
4″ 3/8″ 2 1/2″ & 3″ 300
5″ 3/8″ 4″ 300
6″ 3/8″ 5″ 250
9″ 3/8″ 6″ 200

1/4″-14 x A” HWH w/ Washer
This Fastener can be purchased in any quantity – Increments of 250 are not required
Thru-Panel fasteners with washers are used to attach the panels to the supports from the exterior face. The washer provides a seal where the fastener penetrates the panel, and they are typically placed at the low point of the mesa pattern.
CFR Rake Through Panel Fastener

Through Panel Fastener

Length “A” Head Size Panel Thickness Carton Size
4″ 3/8″ 2″ 500
5″ 3/8″ 2 1/2″ & 3″ 300
6″ 3/8″ 4″ 250
7″ 3/8″ 5″ 250
8″ 3/8″ 6″ 200

12-14 x 1″ TEK3
Fasteners sold in quantities of 250 only
Fastener is used at the ridge and high eave closures

Outside Closure Fastener

Head Size Material Carton Size
5/16″ Carbon Steel 2,500